PullRite 3" SuperGlide Lift Kit for 14/16/18/20K Hitches

Wish I would have bought it sooner. The 3 inches would have saved damage to both the truck bed rail and the trailer. $2700+ for repair and replace. I had pulled the trlr without the riser for over a year without an issue. Only takes once. Install was easy, hitch is still below bedrail height (barely). Peace of mind is worth the cost.
Dyers shipped quick, best price on the web.

I ordered the lift kit to raise the 5th wheel landing gear higher off of the ground. It needed the additional three inches. Installed very easily, and the hitch still mounts the same. I take my hitch out when not in use as haul a lot of stuff in my truck, so easy installation is important.

great hitch fast service

I was glad to have the clearance between the camper and the bed rails including the clearance between the king pin hitch and tailgate.
Overall the whole system works great with my SuperGlide. The only fall back is it would have been nice to keep my superglide rated at its 20,000 pound capability instead of dropping down to 18,000 pounds do to the lift. Other then that I wouldn't change a thing. Great product thinks again to Dryers RV for my complete hitch set up for my 2004 dodge 2500 quad cab short bed.

The truck it self has a B&W gooseneck hitch in it and thanks to Dryers RV I was able to purchase an adaptor rail mounting kit to install the super glide hitch to the B&W hitch so I wouldn't have to lose my gooseneck hitch either.

Thanks, Travis

This is essential for your 2013 and 2014 F150 hitch installs. Works great, looks good, and provides the needed clearance for backing your rig around and into uneven areas (like all raised road beds).

First time 5th wheeler and having a short bed on a 2012 4x4 GMC 3500 CC with the factory overload springs. I put a Superglide #4400 in the bed and not having the trailer yet (was on order) I thought I better order this lift kit to give more options when I go get the trailer. Once I put the super rails in, I went ahead and put these lifts in and then the #4400. When I got to the Cedar Creek dealer, I was very glad to see that when hitched, the rig was perfectly level and I had an additional 3" of clearance between the edge of the truck bed and the underside of the 36B4.

I also want to pass on that even with the extra lift, I could still get my Retrax Pro bed cover over the plate. I made a mini-cross out of a short 4x4 and a 2x4 - the 2x4 sits in the space between the slide rails of the #4400 and the 4x4 sits across the slide rails holding the tilt of the hitch plate level enough for the bed cover to roll right over it. I love it when a plan comes together.

All in all a great product and Dyers has the best prices, as well as the best customer service out there!