FloJet Portable RV Waste Pump System

Dumping your RV waste tanks is the slowest, messiest job in the RV world, but not anymore! The FloJet portable RV Waste Pump System chomps down the waste in your holding tanks to garden hose size at 25 gallons per minute. Macerators are one of the greatest parts invented for RVers. The FloJet Portable Waste Pump breaks up all the waste in your grey and black water tanks to 1/8 of an inch making dumping quick and easy. Simply clip on the FloJet Macerator to your waste valve assemble with the convenient bayonet hooks, the FloJet is faster and easier than the old stinky slinking emptying a 40 gallon holding tank in less than 5 minutes!

Have you searched the RVers travel guide trying to find a dump station on the way to the next campsite? With the FloJet Portable RV Waste Dump System you can dump your tank into your toilet at home or sewer drain, no more stops at expensive dump stations before you reach the house after your trip!

The FloJet Portable RV Waste Pump macerator has two attachment nozzles, one for a standard garden hose to flush the system and the other for a garden hose to dump the system. You do not need to buy costly sewer hoses made for RV’s, a standard ¾” garden hose from the local hardware store is all you need.

You want to keep your distance from the macerator as it works its magic? There is a remote start that comes with 6’ of lead wire so you can remotely activate your FloJet Waste Pump. A Handy, rugged and portable storage case protects the system and all its components; macerator, remote control and power cord when it is not in use.

Are you worried about powering the FloJet Macerator System? Check out these fun facts from the people at FloJet about supplying power to the FloJet Portable RV Waste Pump System

When installing the pump it is recommended that when using a power source that is 1-10' away you use 12 AWG wire. When using power at a distance of 10-20' you should use 10 AWG wire. Remember the normal properties of wire when installing your pump, the longer the distance, the bigger the wire should be the rule of thumb to follow. It is also recommended that a 20amp Fuse/Breaker be used. Many customers make their own power extension line out of 10 GA marine grade wire or similar and a 20 amp fuse. Alligator clips attached to the ends allows the power to be drawn from chassis, house or toad battery. Many customers find this to be the most simple solution for drawing power to the macerator pump and also keeps it truly portable as there is nothing hardwired. If your generator is near the waste compartment the 12 volt starter cable may be a substitute for the 12 gauge wire and a convenient source of power for use with jumpers and a more permanent hookup.

**DUE TO HEALTH HAZARDS THIS ITEM IS NON-RETURNABLE, IN THE CASE OF A DEFECTIVE UNIT IT WILL BE EXCHANGED**