TorkLift StableLoad Quick Disconnect Ford/Chevy/Dodge/Nissan/ Toyota (Lower Overload)

$463.62
5+ In Stock
Item #
88925
Specifically engineered for Ford and Chevy vehicles equipped with lower overload springs that come already predrilled from the vehicle manufacturer.
More Information
Item # 88925
Brand TorkLift
Model A7311
Fits Please see Fit Chart located in the "Useful Downloads" Section.
Features Engages and disengages in seconds
Legendary Lifetime warranty
Quick no-drill installation
Dramatically improves safety, handling and sway reduction
Significantly reduces side to side sway and body roll
Works great with airbags lowering airbag overload air pressure
Angled design to maximize spring contact surface
Anti-rotation key tabs
Included (4) StableLoads
Warranty Lifetime
Made in USA
Special Order Item No
UPC 874929010682
LTL Freight No
WARNING: This product can expose you to chemicals, which is known to the State of California to cause cancer and reproductive harm. For more information, go to www.P65Warnings.ca.gov.
StableLoad Quick Disconnect (Lower Overload) Part #A7311 (With drill kit).

A7311 (WITH DRILL KIT) will fit any passenger or commercial vehicle, van, SUV, truck, RV etc., with rear leaf springs and a lower overload spring. The lower overload leaf can be identified by being on the very bottom of the spring pack. It's thicker than the rest of the leaf springs in the spring pack usually has a gap between the lower overload leaf spring and the upper leaf spring pack.

-Drilling four 7/16 holes required. Specially treated drill bits and detailed drilling instructions are included.
-Average drill time is 30-40 minutes for complete installation
-Many factory overload springs come pre-drilled with 1/2" holes. Drilling holes in the overload springs in the same factory locations found on vehicles with pre-drilled holes will have no affect on your spring's integrity or operation. The drilled springs (when drilled in accordance with the Torklift International drilling specifications) and the integrity of the springs once drilled are covered under the Legendary Lifetime Warranty.
-Some overload springs may have adhesive padding on top of the overload spring, Use a screwdriver or equivalent to remove the padding. This will ensure proper rotation and ease of use.

The StableLoad Quick Disconnect (lower overload) Part #A7311 (with drill kit) is designed as a universal vehicle application for trucks, SUV's, vans, commercial applications and other vehicles equipped with lower overload springs that -- DO NOT -- come already pre-drilled from the vehicle manufacturer (see application guide). The StableLoad Quick Disconnect DRILLING REQUIRED kit (part number A7311) is available for installation with amazing results. This kit comes with four specially treated drill bits and specific instructions for drilling the required (four) 3/8" diameter holes through the ends of the lower overload. The average time to complete the drilling process is approximately 35 minutes. Each precision crafted StableLoad kit carries our Legendary Lifetime Warranty and is proudly made in the USA.
4 out of 5
(1 Reviews)
5 star
0%
4 star
100%
3 star
0%
2 star
0%
1 star
0%
    1 customer reviews
    What's this? Check "Remember Me" to access your shopping cart on this computer even if you are not signed in.