How to Install Your RV SnapPads | RV SnapPad®

Installing SnapPad®


Install Your SnapPad® in Seconds

Watch the video or follow the steps below.

Step 1

Step 1

Simply place the SnapPad underneath the metal foot of the RV.

Step 2

Step 2

Lower the foot into the cavity and continue to apply pressure until the lip wraps over the edge of the foot. You'll know it's in place by the distinctive snap!

We recommend using some dish soap around the inner lip to help snap it into place. WARNING: Do not use petroleum based lubricants (i.e. Silicone or WD 40), as this can erode the SnapPad.

Step 3

Step 3

Now your SnapPads are permanently installed and ready to effortlessly level your RV across any surface. It's just that easy.

Step 4

Step 4

Should your SnapPad not install, raise your foot 3 - 4", place a shim on the side of the pad, and lower the foot. The shim will help snap the pad into place.

CAUTION!
Be sure to keep your fingers away from pinch points while installing your SnapPad!